Satel addition of Zones problem

Hello!

I am facing an issue with the SATEL driver, which I would like to describe below.

I have added the driver and it is connected successfully. I am using only one partition, partition “1”. Everything works fine in general.

The problem occurs with some of the zones. I have a total of 155 zones. I have not added all of them, but approximately the first 30 zones, from 1 to 30, work fine. Then I added zones 153, 154, and 155, which are one magnetic contact and two motion detectors. I cannot get any values from these zones, especially the “Open” value, which is the most important in my case.

Additionally, when I try to run one of the functions, such as “ZoneBypass” or “ZoneUnbypass”, I get the following message:

“Index was out of range. Must be non-negative and less than the size of the collection. (Parameter ‘index’) Actual value was 152.”

The number in the “Actual value was...” part is the zone number minus 1. For example, for Zone 155 it displays “Actual value was 154”, for Zone 154 it displays “Actual value was 153”, etc. I should also mention that I have checked the zones from the SATEL keypads, and their statuses work correctly.

I discovered that the problem starts from Zone 129. Up to Zone 128, I can add the zones normally, see their values, and run the functions without any issue.

Do you have any idea what exactly the problem might be and how it can be solved?

Thank you in advance.