Using version 4.9.0. When importing new KNX data through xml file, the import tool shows that these objects already exists. But in reality they don't. Import does go smooth using export data from ETS6.
Hello Kristian,
if you select the ones that show "already exist" and import them, does it not import them still?
Best regards,
Any update? Issue still presisting.
Hello Kristian,
we're still working on resolving this problem. If you select the group address and change the value type from 5.000 undefined to 5.001 (scaling) does that work?
Best regards David,
Hello Kristian,
we're still working on resolving this problem. If you select the group address and change the value type from 5.000 undefined to 5.001 (scaling) does that work?
Best regards David,
Yes it does fortunately.
Hello Kristian,
great to hear that at least that can be changed so you can still normally use the devices.
We're working in fixing this issue and you should be able to see a fix with the next update.
Best regards.
Hello.
If I select them to force import they are imported into KNX but issue is that new adresses is label as already exist and if you dont force it to import it wont. Also new thing for me is that with some of datatypes as percent is incorrectly importing them. When I import percent for blind it import it as general 5.000 not as 5.001 scaled to 0-100% as used to be, it import as general so I manualy need to edit it to scaled value.
Kristián,
could you provide an example where you get data types imported incorrectly (5.000 instead of 5.001)?
Same issue here.
Just added a few new group addresses in ETS 5.7, export group addresses to XML. When I try to import in bOS 4.9.1, new addresses are marked 'already exists'. That was kind of a surprise to me, so I went to check the KNX devices but the addresses mentioned were not really there. So I choose to 'overwrite' the existing addresses.
If you have just a few addresses then you could handle it but when you have large project, then this could be a serious issue?
Hello,
the issue has already been resolved and will be available in the new release (hopefully this week).
Best regards
Hello Kristian,
if you select the ones that show "already exist" and import them, does it not import them still?
Best regards,
Hello.
If I select them to force import they are imported into KNX but issue is that new adresses is label as already exist and if you dont force it to import it wont. Also new thing for me is that with some of datatypes as percent is incorrectly importing them. When I import percent for blind it import it as general 5.000 not as 5.001 scaled to 0-100% as used to be, it import as general so I manualy need to edit it to scaled value.