Hello, I'm would like to open door via DoorBird from BOS client
I imported DoorBird library example
Camera integration works fine
Relay 1 on Device Control (with same IP configuration) is not working
Any idea?
Many thanks in advance
BR
Alessandro
Hello,
I'm not using the Doorbird example. But I can tell you that I have the lock working with an HttpRequest.
Can you confirm if the model you're using has indeed more than one relay?
I usually use the D1101V which I think it only has 1 relay. So if that's the case, probably the system is trying to execute (according to the example) the cgi command bha-api/open-door.cgi?r=1 when it should only execute bha-api/open-door.cgi without the ?r=1
If it helps, in my configuration, where I'm not using the Doorbird example:
I have a task for the lock, which is basically a HttpRequest calling http://10.0.50.210/bha-api/open-door.cgi in my configuration
Inside the HttpRequest, I've set the username and password of the unit.
And I'm done, it's working.
Try to remove the ?r=1 from the Relay 1 command under Device control and try it again.
Hope it helps.
Best regards
Btw, one way to be sure if the lock is working via url, is to run the url on a browser and check if it's working.
For your unit, you can try both urls, with and without the ?r=1
This way you can check if your unit needs the ?r=1
In my case, it doesn't, because the units I use only have one relay.
Hope it's useful.
Best regards