can't get Z wave thermostat fan speed control
i have MCOHOME zwave thermostat, and i have 2 different models i try to add it in BOS after adding i didn't get fan speed control except on that others are ok.
please help.
Replies 20
Hello,
a new stable release was released, where we added the fan control, heating and cooling control, so try and install the latest update and see if you're finally able to control all the nodes of the device.
Best regards.
one more problem in MH6-HP, i have HEAT and COOL mode but i get only one setpoint nodes
hi, MCOHOME MH6-HP is ok, but MH6-FC is not, FAN Speed in heat mode, nodes are there but it didn't work in cooling mode nothing at all.
MH6-HP have only 2 mode AUto and ON
MH8-FC have 4 mode, LOW, MID HIGH, AUTO
Hello,
a new beta release was released today (4.8.3) where the missing command classes should be integrated.
Please try updating to the latest beta and check if you get the missing nodes for fan control.
Best regards.
and to be added base on my observation, when i update the BOS to 4.8.2 i face problem also in multi channel association which is not a problem in older version of bOS.
i am doing test now with calibri and jigsaw, i update the cabilibri to beta version 4.8.2 and keep the jigsaw in cuurent bOS version, now i can make multi channel association with jigsaw without problem, but in cablibri i couldn't and it show error.
Hello,
unfortunately these tweakes didn't make it to thhe 4.8.2 update... They will be added in the next beta version.
Best regards
Hi, i make sure that i have the beta version 4.8.2, and again i remove and add again two zwave thermostat but still no fan speed, please have a look in image below,
Hello,
did you just select the device and remove it and then clicked discovery or did you go with the full process of Excluding the device and Including it back in?
Best regards.
I'll try it
and give you feedback.