Z-wave Alarm Command Class -not available

Hi,

I have installed and added to Z-wave node the Carbon Monoxide Detector, ZCOMBO from First Alert.

Based on the manufacturer manual the following command classes are supported:

• BASIC

• BATTERY

• CONFIGURATION

• ASSOCIATION

• ALARM_V1

• MANUFACTURER_SPECIFIC

• VERSION

When integrated in bOS I do not see the Alarm Command Class being available. Here are the parameters that I am looking for to monitor:

Alarm                                    Alarm Type                        Level

Smoke Alarm                    0x01                                      0x00 or 0xFF

CO Alarm                            0x02                                      0x00 or 0xFF

Malfunction Alarm          0x09                                      0x00 or 0xFF

Test Alarm                          0x0C                                      0x00 or 0xFF

Heartbeat Alarm              0x0D                                      0xFF

CO Sensor End of Life    0x0E                                      0x00 or 0xFF

I was assuming to find all the alarms under "Notification" class command, but only the following are available:

The values are not changing when the Test Alarm is active(the test button is pushed).

The Battery value has changed, that's how I know the device is communicating.

The device is Associated to Controller 1.

Could you please advise if the alarms can be monitored in bOS?

Thank you,

Calin