bringing my blinds from KNX to CC

Avatar
Bernhard Haba
  • updated

Hello guys,

I need your help on the subject of shading.

I have my blinds now all integrated in KNX and placed on the glass buttons in the respective rooms - now I want to bring the also in ComfortClick and fail.

As a device it is displayed to me but "Boolean" and I suspect here is also the error.
In the demos I find only "Int32" but I can not configure it in this way!?

Where is my wrong thinking?

Is there a description of what I have to watch out for?

Is perhaps in the ETS5 a wrong data value that is output?

Please for your experienced help.

bw

Bernhard

Replies 7
Avatar
1
Jürgen Jürgenson

Hey,

Use the 1byte positioning and status. In bOS change its Data type to shades(percentage) and you should be set. 

Avatar
0
Bernhard Haba

Thank you - this helps me a little bit but they are still not reacting.

It works fine from the MDT glass button.

The Telegram is sent in the KNX-Bus but nothing is reacting on it - the telegram is looking equal for me.

Any other ideas?

Avatar
0
Jürgen Jürgenson
Quote from Bernhard Haba

Thank you - this helps me a little bit but they are still not reacting.

It works fine from the MDT glass button.

The Telegram is sent in the KNX-Bus but nothing is reacting on it - the telegram is looking equal for me.

Any other ideas?

That's a 1bit value in the picture use this with your buttons - up/down. Can you show us the full list of object you have available for the blinds controller. There should be a percent control value too and its status.

Avatar
0
Bernhard Haba

Yes for sure.


I have:

- long action

- short action

- respond position 

- respond tilt

- position 

- position tilt


My groups are:

2/0 safety/room/central

2/1 open/close

2/2 step/stop

2/3 status

2/4 scenes

So i have to give a value to the scenes? 50% or anything else?



Avatar
1
Jürgen Jürgenson
Quote from Bernhard Haba

Yes for sure.


I have:

- long action

- short action

- respond position 

- respond tilt

- position 

- position tilt


My groups are:

2/0 safety/room/central

2/1 open/close

2/2 step/stop

2/3 status

2/4 scenes

So i have to give a value to the scenes? 50% or anything else?



Try respond position and position. 

I use these two in my bOS visu. One button slider.

Avatar
0
Fabien Fuster

Hi Bernhard,

I guess the data type for the following one are either 1.001 or 1.008

- long action

- short action

while these one are 5.001

- respond position

- respond tilt

- position

- position tilt

Jürgen is using only the position and position tilt to set the blind position in his project and therefore only two slider in % value in bOS (5.001 value type).

I guess also the 2/1/2 is on your input 166 or 167, correct ? Can you share a printscreen of your ETS, it might help to understand ?

Personally, i have all command setup in my project (up/down, stop; position, tilt position) as I did find it convenient for my way of using bOS..

Avatar
0
Bernhard Haba
Quote from Jürgen Jürgenson

Try respond position and position. 

I use these two in my bOS visu. One button slider.

Thank you - your Screenshot was my solution. (but the other also heps a lot)
I created a new group adress for % and this could be sent by CC perfectly.

Thank you very much


Customer support portal powered by UserEcho